turn signal RENAULT CLIO 2003 X65 / 2.G Owners Manual

QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page55
1.47
INSTRUMENT PANEL(continued)
The presence and operation of the warning lights, described below, depend on the vehicle equipment and
country.
9STOP light
It goes out as soon as
the engine starts.
This lights up together with
one of the warning lights:
Engine immobiliser
system indicator light
This light performs
several functions.
Refer to the information on the
engine immobiliser in Section 1.
SERVICE warning light
This lights up when the
ignition is switched on
and goes out after a few
seconds. If it lights up when the
vehicle is being driven, it is
advisable to stop at a Renault
Dealer soon.
It lights up together with one of
the warning lights:9Left turn signal
indicator light
Low fuel level warning
light
It goes out as soon as
the engine starts.
If it lights up or remains lit, fill
up with fuel as soon as
possible.
Right turn signal
indicator light
Electronic Stability
Program (ESP) and
traction control
indicator light
There are several reasons for
this warning light coming on:
see Section 2 for information
on the Electronic Stability
Program: ESP and the Traction
control system.9Preheating/electronic
fault or water
in the diesel
warning light.
• Preheating indicator light
This light should come on
when the ignition key is in
positionM; it indicates that
the heater plugs are
functioning. It goes out after
preheating is sufficient and
the engine can be started.
•Electronic fault/or water
present in the diesel warning
light
If it comes on while driving,
it indicates an electronic
fault or that water is present
in the fuel. Consult your
RENAULT Dealer as soon as
possible.

1
2
13
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page63
1.55
EXTERNAL LIGHTING AND SIGNALS
Side lights
Turn the end of stalk1to
align the symbol opposite the
mark3.
The instrument panel lights up. The
brightness of the lights can be
modified by turning wheel2,ifthis
feature is fitted to the vehicle.
Dipped beam headlights
Automatic operation
With the engine running, vehicles
fitted with alight sensor,the
dipped beam headlights light up
automatically as light begins to
fade; stalk1does not need to be
turned (position 0).
To deactivate or reactivate this
function, move the end of stalk1
twice consecutively from 0 to side
light position, with the engine
stopped and the ignition on.Automatic operation (continued)
A bleep confirms the deactivation of
this function, and two bleeps
confirm its reactivation.
Manual operation
Turn the end of stalk1until the
symbol appears opposite mark3.
An indicator light lights up on the
instrument panel in all cases.
Headlight main beam
When the dipped beam
headlights are on, turn stalk1
towards you (an indicator light
lights up on the instrument panel).
To return to the dipped headlight
position, pull the stalk towards you.
Switching off the lights
Turn the end of stalk1back
to its original position.
Before setting out to drive at night:
check that the electrical equipment is in good condition and adjust the headlight beams (if your vehicle is not
carrying its normal load). Check that the lights are not obscured (by dirt, mud, snow or objects which could
cover them).

45
4
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page64
1.56
EXTERNAL LIGHTING AND SIGNALS(continued)
Front fog lights
Turn the central ring4of
the stalk to align the symbol with
mark5.
Operation of the fog lights depends
on the external lighting selected and
a warning light will light up on the
instrument panel.
Rear fog light
Turn the central ring4
of the stalk to align the symbol with
mark5.
Operation of the rear fog light
depends on the external lighting
selected and a warning light will
light up on the instrument panel.
Remember to turn this light off
when it is no longer needed to avoid
inconveniencing other road users.The front and rear fog lights switch
off when the exterior lights are
switched off.
Special case
The front and rear fog lights do not
operate in automatic mode.
They only come on if the end of
ring1is in position or
.
Lights on warning buzzer
A warning buzzer will sound when
a front door is opened and the lights
are left on after the ignition has been
switched off (to prevent discharge
of the battery).

1
31
0
2
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page70
1.62
AUDIBLE AND VISIBLE SIGNALS
Horn
Press on the central cushion of
steering wheel2.
Headlight flasher
To flash your headlights, even if the
lights are not in use, pull the stalk1
towards you.
Special case
If automatic operation for dipped
headlights is activated, first pull
stalk1towards you to light the main
beam headlight then again to turn
them off.
Hazard warning lights
Press switch3.
This switch lights up all four
indicators at the same time.
It is to be used in cases of danger to
warn other road users that you:
• are obliged to stop in a normally
prohibited location,
• are obliged to drive under
particular conditions.
Direction indicators
Move stalk1parallel to the steering
wheel and in the direction in which
you are going to turn.
When driving on the motorway, the
steering wheel is not often turned
far enough to return the stalk
automatically to position0. There is
an intermediate position in which
the stalk can be held when changing
lanes.
When the stalk is released, it
automatically returns to0.